5. ALARMS 5.2 LIST OF TRANSMISSION CONTROL UNIT ALARMS ALARM N° 85 DESCRIPTION The control unit detects a problem affecting the shuttle control lever. ECU RESPONSE The control unit limits operation to “TC-SHUTDOWN” mode and the transmission reverts to neutral, emitting a continuous beep. CHECK Check that the contacts on connector “X37” and on connector “ECU PS” of the transmission control unit are firmly at- tached and not oxidised. Verify the correct operation of the shuttle lever (for details see section 40).
With the starter key in the “I” (ON) position, check that the power input to the shuttle control lever is correct (12V meas- ured between pin 3 (positive) of connector “X37” and cab earth) With the starter key in the “O” (OFF) position and connector “ECU PS” unplugged, connect a test meter in alternation to pin 1, pin 2, pin 3 and pin 4 of connector “X37“ and to cab earth, and measure the resistance to verify whether or not there are short circuits to earth (meter reading: infinity).
With the starter key in the “O” (OFF) position and connector “ECU PS” unplugged, connect a test meter to pin 1 of con- nector “X37” and in alternation to pin 2, pin 3 and pin 4, and measure the resistance to verify whether or not there are short circuits (meter reading: infinity). With the starter key in the “O” (OFF) position and connector “ECU PS” unplugged, connect a test meter to pin 2 of con- nector “X37” and in alternation to pin 3 and pin 4, and measure the resistance to verify whether or not there are short cir- cuits (meter reading: infinity).
With the starter key in the “O” (OFF) position and connector “ECU PS” unplugged, connect a test meter to pin 3 of con- nector “X37” and to pin 4, and measure the resistance to verify whether or not there are short circuits (meter reading: in- finity). With the starter key in the “I” (ON) position, connect a test meter in alternation to pin 1, pin 2 and pin 4 of connector “X37“ and to cab earth, and check that there is no voltage registering (meter reading 0V). Clear all alarms, turn the starter key first to “O” (OFF) and then back to the “I” (ON) position again, and if the alarm is still present, the control unit must be renewed.
20-126 0.012.8732.4 1 2 20 21 23 45 63 65 68 2145 23 68 1 2 6365 20 ECU PS GND4 J2 AS4 3 6 F35 F27 7.5A 7.5A +15 +30 0441.9533 20 18 21 19 X37 3 1 4 2 Ohm Ohm Ohm 3.9 3.9 3.9 FW N RV 0443.8656 D0017500 21 45 23 68 1 2 63 GND4 J2 3 20 18 3 1 3.9 Ohm