Deutz — 5.3.2 ANALYSIS OF ALARMS

5. ALARMS 5.3 LIST OF ALARMS DISPLAYED BY SERDIA SERDIA ALARM N° 3 DESCRIPTION The engine control unit detects that the signal from the wheel speed pickup is either non-existent or incorrect. CHECK Using the ART, check that the lift control unit is receiving the wheel speed signal, or if it has detected the “WheelSen- sorDisc” alarm corresponding to flash code 42 (standard) or 64 (text). If the lift control unit detects the alarm, check out the system following the procedure described for “WheelSensorDisc”. If the control unit is receiving and acknowledging the signal correctly, check for electrical continuity between pin 3 of connector “ISO7” and pin 6 of connector “X8”.

Check that the circuit board attached to connector “X8” is not damaged (for details, see section 40). Check for electrical continuity between pin 5 of connector “X8” and pin 7 of connector “MX2”. Connect a test meter to pin 5 and pin 6 of the circuit board attached to connector “X8” and, using the diode test, check that the diode is operational (negative prod on pin 6, positive prod on pin 5). Connect a test meter to pin 5 and pin 6 of the circuit board attached to connector “X8” and+ measure the resistance, which should read 2200 Ohm approx (negative prod on pin 6, positive prod on pin 5). Check on page 24 of the “Configuration” menu that the value of “1301:VelocityFactor” is 130.

If the fault persists, reprogram or renew the control unit. 20-142