Deutz — 3.2 DEST 45 PROGRAM DESCRIPTION

6. EDS (Electronic Diagnosis System) 3. POWER-SHUTTLE DIAGNOSISPROGRAMM DEST 45 Control > End of line programming CAUTION! After terminating the menu item ”Activate outputs” the ignition on the vehicle needs to be switched off and on again before the menu item ”End-of-line programming” can be selected. Otherwise the call is aborted by prompting the error message ”Select transmission version not possible!”. The menu item ”End-of-line programming” opens a divided window for the purpose of configuration of the trans- mission box and for adjustment of the clutch. In the upper window area the configuration data is displayed.

In the lower area the user can find instructions for the end-of- line programming. Fig. 37 - End-of-line programming First the program reads the 8 digit vehicle identification number from the EEPROM. If the first four digits correspond to a valid vehicle identification prenumber the configuration data are read directly from the box. If the configuration data of the box are consistent to the corresponding data of the vehicle identification prenumber all data (transmission ver- sion, type of transmission, vehicle configuration, electronic box and vehicle identification number) will be displayed. If they are not consistent only the read out data from the control unit will be displayed.

In addition, a warning will appear with instructions to reconfigure the box. The same applies if the vehicle identification prenumber read from the EEP- ROM is invalid. The vehicle configuration can be changed by means of selecting the button > or the letter ”F”. At first the vehicle identification prenumber (the first four digits of the vehicle identification number) is highlighted in a different col- our. The vehicle identification number defined for the corresponding type of vehicle can be selected from a table stored in the program by means of the cursor keys. The configuration data belonging to the respective type of tractor are al- tered simultaneously.

Before these data are stored by pressing the ENTER key it is obligatory to compare the pre-set speed version (30 / 40 km/h or 50 km/h) with the actual speed version of the tractor. If these do not match the proper speed version has to be set by means of pressing the cursor keys again. 20-195