EDS (Electronic Diagnosis System) POWER-SHUTTLE DIAGNOSISPROGRAMM DEST 45 20-208 Remarks • Inadmissible speed discontinuity from transmitter failure threshold to standstill threshold • Upon reversing demand neutral shifting, permanent beep • Switch point out of tolerance range • Self preservation • Upon neutral shifting • HK pedal switch is closed with HK pedal in idle position • HK pedal sensor signal: Idle: LOW stepped: HIGH • Upon neutral shifting permanent beep • Possibly sequence error from: LU sensor supply (AU1) • Limit values: 0,5V Umin approx. 4,5V Umax approx. • Possibly sequence error from:
• EMERGENCY K+ temperature sen- sor or OPERATION K+ sensor sup- ply AU1 • Upon neutral shifting permanent beep • Limit values: 0,5V Umin approx. 4,5V Umax approx.
possible remedy Ignition off/on Check cabling Check speed sensor Ignition off/on End-of-line programming Carry out/repeat permanent beep Check/adjust mechanical tolerance, Of the HK pedal sensory system Check cabling Check HK switch Check sensor supply Check sensor/switch LU, KM, K+ Check cabling Check sensor mounting Check sensor Check sensor supply Check cabling Check sensor mounting Check sensor Check sensor supply System reaction Operation mode LIMP-HOME Neutral shifting Operation mode EMERGENCY OP- ERATION HK pedal adjustment Neutral shifting Operation mode EMERGENCY OPERATION Neutral shifting Operation mode EMERGENCY OPER- ATION Error location/error cause nMOT speed transmitter gradient (Plausibility) Clutch pedal sensory system plausibility Sensor/switch Clutch pedal sensoryl system LU, KM Clutch pedal sensory system K+ Code 58 64 65 66 66