EDS (Electronic Diagnosis System) POWER-SHUTTLE DIAGNOSISPROGRAMM DEST 45 3.6 OTHER INFORMATIONS 20-214 possible remedy Check supply paths LU, KM Check fuse (term15, term30) Check communication line (LU) Ignition off/on, repeat Check supply paths LU, KM Check fuse (term15, term30) Check communication line (LU) Check/correct end-of-line programmed in programmazione fine linea Check cabling speed sensor Nmot and Nlsa Check speed sensors Nmot and Nlsa Check hydraulic system Check/correct end-of-line programmed vehicle version Check cabling speed sensors Nmot and Nlsa Check cabling transfer valves GV1/GV2 Check speed sensors Nmot and Nlsa Check hydraulic system Check/correct end-of-line programmed vehicle version Check cabling speed sensors Nmot and Nlsa Check speed sensors Nmot and Nlsa Check hydraulic system Check starting block signal (LU, KM, K+) possible error cause EST45 is not running up Communication line defective Power supply defective EST45 is not running up Communication line defective Power supply defective Wrong vehicle version selected upon end-of-line programming vehicle version Speed sensor Nmot and Nlsa defective Fault in hydraulic system (neutral by reversing monitoring) Wrong vehicle version selected upon end-of- line programming Speed sensor Nmot and Nlsa defective, interchanged Transfer valves GV1/GV2 interchanged Fault in hydraulic system (pressure modulation by GV toggling) Wrong vehicle version selected upo end-of-line programming Speed sensor Nmot and Nlsa defective Fault in hydraulic system (pressure modulation by GV toggling) Starting block signal not existing Error consequence/System reaction no display activation resp.
display ”EE” Diagnosis tool cannot establish connection Upon starting/reversing powershift gear shifts over to neutral (jerk can be observed). display: ”N”, FR-arrows flashing, no error code, permanent beep Automatic shifting upward/downward in the splitter, shifting noise every 1-2 sec. Short traction force interruption during driving with Closed drive train (LS pressure modulation) Automatic starting not possible, vehicle remains in neutral