SERDIA SETUP AND COMMUNICATIONS 9. SERDIA (LEVEL III) 1. SETUP AND COMMUNICATIONS SERDIA is a software program. Together with the notebook and the interface, it constitutes a tool which serves as an aid to communication with the engine ECUs. SERDIA supports DEUTZ ECUs EMR, EMS and MVS. You can also communicate with three different ECUs using just one software product. Any changes you wish to make to the ECUs as far as settings, parametrizations, error deletion and calibra-tion are con- cerned are only possible with SERDIA. SERDIA runs under the MS Windows®3.11 and Windows95 (98) user surface. You can choose English or German as the user language when carrying out program installation.
The user surface enables the user to call up the functions required simply by clicking on the appropriate buttons. The menu points listed below are available: ECU selection Measured values Parameters Error memory Function test Extras 1.1 MINIMUM EQUIPMENT REQUIRED To run SERDIA, the following minimum equipment configuration is required:
1.1.1 CONTROL UNITS EMR1, Electronic engine controller System description TN 0297 7432 EMR2, electronic engine controller System description TN 0297 9885 MVS, solenoid valve system System description TN 0297 7488 EMS2, engine monitoring system System description TN 0297 7930 1.1.2 DIAGNOSTIC CONNECTOR Serial diagnostic connector TN 0419 9615 as specified in ISO 9141 and SAE J1587 1.1.3 INTERFACE Link from control module (engine) to PC Level adaptation for ISO 9141, SAE J1708 and RS 485 Security system with dongle, copy protection 12-24 V voltage supply range Supply source:
engine Safety switching for protection against overvoltage and incorrect pole connection Galvanic isolation 1.1.4 PC/ NOTEBOOK Minimum equipment required: Notebook or PC with 1 RS 232 serial interface PC (IBM-AT compatible) (should not be otherwise occupied, for example, mouse or IR interface). Parallel interface for printer Graphics card VGA/SVGA 20-257