METHOD FOR REMOVAL AND REFITTING OF RIGID PIPES AND WIRING 30-1 METHOD FOR REMOVAL AND REFITTING OF RIGID PIPES AND WIRING 1 - After removing pipes, immediately plug the ends of the pipes and the open fittings on the compo- nents from which they were disconnected in or- der to prevent the entry of contaminants. 2 - After disconnecting electrical connectors, pro- tect them against oil, dust and other contami- nants by covering them in bags made of waterproof material and attach the bags to the wiring with insulating tape. 3 - Should any oil, coolant, moisture or water come into contact with the connectors, clean them with compressed air at low pressure (max.
2 bar) and clean the wires and contacts with isopropyl al- cohol or a specific water-repellent product. 4 - Check wiring fixings carefully; these must not im- pinge on the connectors and must be positioned at regular intervals of about 30 cm to prevent vi- bration that could cause an interruption in cur- rent flow or signal loss. IMPORTANT 1 - The rigid pipes of the various systems can all be re- moved individually , i.e. without having to remove any pipes belonging to other systems. 2 - For particularly complex removal operations, num- ber the pipes in the order in which they are removed, label any intermediate connections and the posi- tions of the intermediate retaining clamps.
Refit the pipes in reverse order to removal. 3 - After having repositioned the pipes in their original locations, tighten the fittings by hand and locate the retaining clamps and intermediate fixings. 4 - First tighten the fittings using also a holding wrench to the torques specified in the tables in Section 00, and then tighten the pipe clamps. 5 - To help the operator trace the routes of the rigid pi- pes and cables on the tractor frame, the following photos show the relative positions of pipes and ca- bles for the version with air trailer braking.