Deutz — Tension of the compressor drivebelt

AIR CONDITIONING SYSTEM Maintenance The checks and servicing operations required for the air conditioning system are as follows: 4 - Inspection and renewal of the electromagnetic clutch pulley (to be carried out at a specialised serv- ice centre). 1 - Checking the tension and condition of the compres- sor drivebelt. 5 - Removal and renewal of the receiver-drier. 2 - Discharging, flushing and recharging of the system using a specific servicing machine and R134 refrig- erant. 6 - Removal and renewal of the condenser. 7 - Removal of the evaporator and the electronic tem- perature sensor. (For these operations see "AIR CONDITIONING EVAPORATOR"). 3 - Removal and renewal of the compressor.

Tension of the compressor drivebelt Before adjusting the tension, carefully examine the drivebelt for signs of wear. The belt must be renewed immediately at the first sign of cracking, fraying or separation of the plies. If a new belt is fitted, re-adjust the tension after ap- prox. 15 operating hours. 1 - Remove the right-hand grille (1). 1 F0077891 2 - Loosen the bolts (2) and (3) securing the air condi- tioning compressor (4) and the tensioner block (5). 3 - Turn the tensioner screw (6) clockwise to tension drivebelt (7) as indicated below: Static deflection ” A ” immediately after fitting: 550±50 N Static deflection ” A ” after 15 minutes:

400±50 N The check should be carried out with the en- gine cold. 2 4 3 5 4 - Tighten bolts (2) & (3). 6 F0078120 7 F0078130 30-39