2. CONNECTING THE TESTER TO THE ELECTRONIC 2.1 CONNECTING THE ART TO THE HYDRAULIC LIFT 2. CONNECTING THE TESTER TO THE ELECTRONIC CONTROL UNITS This chapter describes how to connect the various diagnostics tools provided for the use of the technician. 2.1 CONNECTING THE ART TO THE HYDRAULIC LIFT AND FRONT AXLE SUSPENSION CONTROL UNITS CAUTION Before connecting the ART, switch off the engine and remove the starter key 1 2 5 X18 4 3 F0059410 1 - Connect the cable (1) (code 5.9030.861.4) to the ART (2) (code 5.9030.730.0). 2 - Join the connector (3) of cable (2) to cable (4) (code 0.012.6655.4) and plug connector (5) into connector X18 located internally of the right hand side console.
3 - Check that connectors (5) and X18 are securely connected. 4 - Insert the starter key and turn to the “ I ” (ON) position to power up the tester. 5 - Following power up, the ART performs the battery level test. 6 - Press the key corresponding to the control unit being tested. CAUTION Avoid starting the engine unless required for the purpose of diagnosis or calibrating sensors. 20-9 T E S T M E N U 1 - F r o n t s u s p e n 2 - R e a r L i f t C H O O S E _