PACCAR MX-13 — Starting After the Fuel Tank Has Run Dry or After Fuel System Service has been Performed

ENGINE MAINTENANCE - Maintenance Procedures cap to 30 lb-ft (40 N·m) as specified on the filter cap. NOTE CAUTION Fuel Filter Module - Priming Pump If your vehicle is equipped with a PAC- CAR fuel blending valve, rotate the blending shut-off valve to the PRIME (closed) position before starting the priming procedure. The following instructions should only be used in emergency situations when the fuel tank has run dry. Failure to fol- low the starting instructions below may damage the starter motor. 2 5. If vehicle is equipped with a fuel blending valve, rotate the valve to the RUN/open position.

Fuel Filter Module - Priming Pump NOTE Allowing the engine to idle for several minutes with the fuel blending valve in the prime postition assists in purging air from the fuel system. Starting After the Fuel Tank Has Run Dry or After Fuel System Service has been Performed Procedure for starting the engine after running out of fuel. 4. Replace the chassis-mounted fuel filter per the filter manufacturer's recommended procedure. Follow the steps below to restart the engine: Y53-1181-1K1 (08/2018) 61