Western Star — Western Star (EN)

Vehicle Access Door Locks and Handles To unlock either door from outside the cab, insert the key in the lock and turn it one-quarter turn towards the front of the vehicle. See Fig. 2.1 . Turn the key back to the original position to remove it. Pull out on the paddle latch to open the door. 2 1 1 2 03/21/2001 f720394 1. Lock 2. Paddle Latch 11/02/2011 f545852 1. Unlock Button 2. Lock Button Fig. 2.1, Exterior Door Handle Fig. 2.2, Key Fob To lock either door from outside the cab, insert the key in the lock and turn it one-quarter turn towards the rear of the vehicle. Turn the key back to the origi- nal position to remove it. If the door is closed, it will now be locked.

If the door is open, close the door firmly. Key Fob Programming A maximum of four fobs can be programmed to work on one vehicle. Whenever a new fob will be used, all existing fobs must be reprogrammed at the same time. Any existing fobs that were previously pro- grammed will no longer work on the vehicle unless they are all reprogrammed at the same time. To lock either door from inside the cab, push the lock button down. Pull the lock button up to unlock the door from the inside. 1. Remove the passenger-side electrical access panel, located next to the glove box. See Fig. 2.3 .

To open either door from inside the cab, pull the lock button up, then pull the interior door latch out and push the door outwards. 2. Locate the 2-wire connector in the area between the auxiliary and main power distribution mod- ules (PDMs) with circuit 443 * and ground. Remote Keyless Entry Remote keyless entry is optional on Western Star vehicles. The remote entry key fob can be used to unlock the doors from outside the cab. NOTE: If the 2-wire connector cannot be lo- cated, the connector may be hanging below the PDM. In this case, remove the heater cover panel, which is located below the fuse panel. To unlock both doors, press the unlock button. To lock both doors, press the lock button.

See Fig. 2.2 . 3. Use a short length of wire or a paperclip to short the two terminals together three times within five seconds. 4. Wait three seconds. 2.1