Western Star — Western Star (EN)

Fifth Wheels tractor, possibly causing serious personal injury or death. 5. Drive out from under the trailer. Air-Activated Kingpin Unlock, Jost Fifth Wheels Preparing the Trailer for Uncoupling Before using the air valve to unlock a fifth wheel kingpin, prepare the trailer as follows. 1. Verify that both the parking brake and trailer air supply knobs are out (see Fig. 17.8 ), the tractor and trailer parking brakes are set, and that the trailer is prepared for uncoupling. 1. Set the tractor and trailer parking brakes. 2. Chock the rear trailer tires. NOTE: If the trailer parking brake is not set, the air-actuated valve will not activate. 3.

Lower the trailer landing gear until the weight is removed from the fifth wheel. 4. Disconnect the tractor-to-trailer air lines and elec- trical cable. Plug the air lines to prevent dirt or foreign material from entering the lines. 2. Release the tractor parking brake. 3. Pull and hold the kingpin release valve, then drive forward slowly. Air-Activated Kingpin Unlock, Fontaine and Holland Fifth Wheels 4. After the trailer has slid down the fifth wheel and pick-up ramps, let go of the kingpin release valve. 1. Verify that both the parking brake and trailer-air supply knobs are out (see Fig. 17.8 ), the tractor and trailer parking brakes are set, and that the trailer is prepared for uncoupling.

Fifth Wheel Slide WARNING NOTE: If the tractor parking brake is not set, the air-actuated kingpin-release valve will not acti- vate. Adjust the fifth wheel slide correctly, and do not overload any tractor axle by incorrectly loading the trailer. Incorrect slide adjustment or improper axle loading could cause erratic steering and loss of vehicle control, possibly resulting in seri- ous personal injury or death. 2. Pull and hold the kingpin release valve ( Fig. 17.11 ) until the kingpin lock mechanism opens and locks in place.

On sliding fifth wheel assemblies, the fifth wheel plate is attached to rails that allow forward and rear- ward movement of the fifth wheel in order to opti- mally distribute the load across the axles. Slots are evenly spaced along the slide rails, and retractable wedges are positioned through the slots to hold the fifth wheel in the desiposition. The amount of load distribution on the front steering axle and rear drive axle(s) will have a direct effect on the steering control of the tractor. Determine the front and rear axle weights by weighing the tractor on scales designed for this purpose.

The maximum axle weight ratings are shown on the Federal Motor Vehicle Safety Standard (FMVSS) label or Canadian Motor Vehicle Safety Standard (CMVSS) label attached to the driver-side door frame. The desired load on the axle is no less than 80 percent of the maximum axle weight rating, but in 10/26/2010 f611102 Fig. 17.11, Air-Actuated Kingpin Release Valve 3. Let go of the kingpin release valve. 4. Release the tractor parking brake. 17.7