Western Star — Western Star (EN)

Headlight Aiming Preliminary Checks If the center of any projection is more than 3.9 in (100 mm) to the side of the marks made in step 4, adjust the horizontal aim of that headlight. Before checking or adjusting the headlight aim, com- plete the following inspection: 7. Check the vertical adjustment of the low beams. The center of each beam projection should fall on or near the marks made during step 4. See Fig. 19.2 . Check that the hood is closed and latched. Remove any large amounts of mud or ice from the underside of the fenders. 8. Use Table 19.1 to determine the maximum verti- cal distance allowable between the marks on the wall and the center of each low-beam projection.

Check the springs for sagging or broken leaves. Check the suspension for proper functioning of the leveling mechanism. On cabs with air sus- pensions, make sure that the height is properly adjusted. If the distance between either projection center and the mark made on the wall or screen is greater than the maximum distance given in Table 19.1 , adjust the vertical positioning of that headlight. Check for damage to the hood and hinge as- sembly. Repair as necessary. 9. Turn on the high-beam headlights. Ensure the beam projections are parallel to the ground. If the beam projections are not parallel to the ground, adjust the positioning of the high-beam bulbs.

With the vehicle unloaded, check that the tires are inflated to the recommended air pressure. Clean the headlight lenses. Use a soft cloth with mild, non-caustic soap or detergent, and water. Adjusting Headlight Aim Checking Headlight Aim NOTE: Western Star vehicles are offered with various headlight assembly options. Because of the various options, the location of adjustment screws on your vehicle’s headlight assembly may vary from what is shown here. 1. Park the vehicle on a level surface, 25 ft (7.6 m) away from, and perpendicular to, a vertical screen or wall. Shut down the engine and set the parking brake. Chock the tires. 2.

On each headlight, find the bulb center behind the headlight lens. For adjustment screw locations on a vehicle with dual rectangular headlight assemblies, see Fig. 19.3 . For adjustment screw locations on a vehicle with dual round headlight assemblies, see Fig. 19.4 . For adjustment screw locations on a 4700 model, see Fig. 19.5 . 3. Measure the distance from the ground to the center of each headlight bulb ( Fig. 19.1 , Item A). Note those distances. 4. On the screen or wall, mark the locations of each headlight bulb center using the distances found in step 3. See Fig. 19.1 , Items 2 and 3. Turn the adjustment screw in either direction until the beam pattern meets the acceptable standard. 5.

Turn on the low-beam headlights. NOTE: See the following heading, Adjusting Headlight Aim , for adjustment instructions. 6. Check the horizontal aim of the low beams. The center of each beam projection should fall on or near the marks made during step 4 ( Fig. 19.1 , Items 2 and 3). 19.1