Driver Controls Turn the key counterclockwise to the ACCESSORY position. In addition to all the functions that are oper- able with the ignition switch in the OFF position, the following functions are operable when the switch is in the ACCESSORY position: 6 5 radio/stereo system 5 heater and A/C fan mirror defog windshield wipers beacons 3 4 7 7 power windows windshield washer outside air temperature display Turn the key clockwise past the OFF position to the ON position. With the switch in the ON position, the warning and indicator lamps illuminate. Wait for three seconds before starting the engine.
02/08/2005 f544575 1 2 Turn the key clockwise past the ON position to the START position and start the engine. Do not operate the starter longer than thirty seconds, and wait at least two minutes between starting attempts to allow the starter to cool. Release the key the moment the engine starts. 1. Fog Light 2. Road Light 3. Dual Headlights 4. Turn Signal/Side- Marker Lights 5. Clearance Light 6. Identification Lights 7. Clearance Light Switching on the ignition and releasing the parking brake automatically activates the daytime running lights, if equipped. The daytime running lights will operate until the parking brake is applied or the headlights are turned on. Backup Lights Fig.
4.5, Exterior Lights NOTE: Depending on the mounting, backup lights are sometimes referred to as hook-up lights. Lighting Controls Backup lights activate only when the vehicle is in re- verse, and are designed to be used while backing up at night. IMPORTANT: Unless otherwise noted below, press the upper half of the switch to activate the desired light(s). Press the lower half of the switch to turn the light(s) off. Clearance Lights Exterior Light Controls Press the upper half of the clearance lights switch to activate all clearance lamps including back-of-sleeper and mirrors. Exterior light controls are listed here in alphabetical order. See Fig. 4.5 for exterior light locations.
At the rear of the vehicle there are taillights, brake lights with turn signals, backup lights, and optional utility lights. Driving Lights Driving lights are designed to extend the range of the high-beam headlights, and can only be activated when the headlight high-beams are on. When head- lights are dimmed, the driving lights automatically turn off. See Fig. 4.6 for exterior and interior light switches. 4.3