Western Star — Western Star (EN)

Seats and Restraints Three-Point Seat Belt Sleeper Compartment Restraints NOTE: For vehicles equipped with the Komfort Latch or the Sliding Komfort Latch, see the seat belt operation under the heading Seat Belt With Komfort Latch or Sliding Komfort Latch . WARNING WARNING Do not use the sleeper compartment while the vehicle is in motion unless a bunk restraint is installed and used. Not using the bunk restraint increases the chance of injury, or the degree of injury, from accidents or sudden stops to all oc- cupants of the vehicle. Wear three-point seat belts only as described below. Three-point seat belts are designed to be worn by one person at a time.

In case of an acci- dent or sudden stop, personal injury or death could result from misuse. On vehicles equipped with a sleeper compartment, bunk restraints should be used whenever the sleeper compartment is occupied and the vehicle is moving. Restraints are designed to lessen the chance of in- jury or the amount of injury resulting from accidents or sudden stops. Fasten the seat belts before driving. Fastening a three-point seat belt while driving creates a haz- ard. 1. Slowly pull the link end of the three-point seat belt out of the retractor and pull it across your lap (from outboard to inboard) far enough to en- gage the buckle.

If the retractor locks too soon, allow the belt to retract slightly, then slowly pull it out again. Bunk Restraint Adjustment 1. Make sure the belt is attached to the bunk sup- port and sleeper wall. 2. To lengthen the belt, tip the link end downward and pull the link until it connects with the buckle. 2. Fasten the seat belt by pushing the latch into the buckle. Listen for an audible click. See Fig. 6.8 . 3. Tug on the seat belt to make sure it is securely fastened. If the buckle unlatches, repeat this step. If the problem continues, replace the seat belt. 3. After the belt is connected, shorten it by pulling on the loose end until the belt is snug, but com- fortable.

Be sure the belts are not twisted. See Fig. 6.13 . 4. Snug the seat belt to your waist. 5. Position the shoulder strap diagonally across your chest with the adjustable D-loop bracket (if equipped). The shoulder strap must be centered on your shoulder and chest, away from your face and neck. See Fig. 6.9 . 6. To unbuckle the seat belt, press the release but- ton on the buckle. See Fig. 6.12 . NOTE: Make sure the seat belt is completely retracted when it is not in use. 6.9