Electrical System Vehicles may also be equipped with a secondary PNDB. The secondary PNDB sources power to any of the following: fleet management communications trailer end-of-frame connection shore power inverter bodybuilder PDM (housing any fuses and re- lays necessary for customer-installed truck body equipment) The dash electrical panel is located inboard of the passenger-side glove box. Access to the panel is achieved by removing the four screws located in each corner of the panel cover. See Fig. 8.2 . A decal showing the layout of the fuses, breakers, and relays is on the back of the panel cover. See Fig. 8.3 . 11/13/2001 f543949 1 2 1. Decal Option Panel 2. Decal Main Panel Fig.
8.3, Electrical Panel Decals Battery Disconnect Switches Your Western Star vehicle may be equipped with a cab load disconnect switch (CLDS) or a battery isola- tion switch. Cab Load Disconnect Switch, EPA10 and Newer The optional CLDS ( Fig. 8.4 ) is used to minimize draw on the battery, and should be turned off when the vehicle is parked for an extended period of time. 11/13/2001 f543947 When the CLDS is set to OFF, it signals the PNDB to disconnect battery power to the circuits powered by the MIDI fuses. 1. Electrical Panel Cover 2. Mounting Screws Fig.
8.2, Dash Panel The CLDS is mounted on the cab floor outboard of the driver’s seat, on the lower driver-side dash panel, or near the battery box. Pre-EPA10 Power Distribution Vehicles that are not compliant with EPA10 or newer regulations have one PDM in the engine compart- ment (see Fig. 8.1 ) and two MEGA fuses in the dash electrical panel. IMPORTANT: The ignition should be turned OFF before using the CLDS. Pre-EPA10 Battery Isolation Switch The dash electrical panel is located inboard of the passenger-side glove box. Access to the panel is achieved by removing the four screws located in each corner of the panel. See Fig. 8.2 .
A decal, showing the layout of the fuses, breakers and relays, is on the back of the panel cover. See Fig. 8.3 . The optional battery isolation switch (see Fig. 8.5 ) is located on the cab floor outboard of the driver’s seat, on a bracket near the driver-side kick panel below the dash, or near the battery box. The battery isola- tion switch disconnects the power to most cab cir- cuits and engine power wiring. Use it whenever the 8.2 1 2