Western Star — Western Star (EN)

Engine Starting, Operation, and Shutdown Engine Starting NOTICE This engine chapter is to serve as a guide for best practices only. Each engine model may have operat- ing characteristics that are unique to that particular engine, and will be documented in the engine manu- facturer’s literature. Always refer to specific instruc- tions and recommendations from the engine manu- facturer. If the oil pressure gauge indicates no oil pres- sure, shut down the engine within approximately ten seconds to avoid engine damage. 7. Check the oil pressure gauge for any drop in lu- bricating oil pressure or mechanical malfunction in the lubricating oil system. NOTE:

Before starting the engine, read Chap- ter 3 for detailed information on how to read the instruments and see Chapter 4 for detailed in- formation on how to operate the controls. Read the engine manufacturer’s operating instructions before starting the engine. Cold-Weather Starting See the engine manufacturer’s operation manual for starting aids that are approved for specific engines. Starting After Extended Shutdown WARNING Before engine start-up, complete the engine pretrip inspections in Chapter 23 . Never pour fuel or other flammable liquid into the air inlet opening in the air intake in an attempt to start the vehicle.

This could result in a flash fire causing serious personal injury or property damage. NOTICE Failure to eliminate water-diluted lubricating oil may lead to serious engine damage at startup. An engine in storage for an extended period of time (over winter, for example) may accumulate water in the oil pan through normal condensation of moisture on the internal surfaces of the engine. Oil diluted by water cannot provide adequate bearing protection at start-up. For this reason, change the engine oil and filters after extended storage. 1. Before engine start-up, complete the engine pre- trip inspections in Chapter 23 . 2. Set the parking brake. 3. Place the transmission in neutral.

On vehicles with manual transmissions, fully depress the clutch pedal. 4. Turn the ignition switch to the ON position. The buzzer will sound for three seconds. Engine Operation Safety and Environmental Considerations During cold conditions, the WAIT TO START lamp may illuminate. Wait until the lamp goes out before turning the ignition key to START. NOTE: The length of time the WAIT TO START lamp remains illuminated depends on the ambi- ent temperature. The lower the ambient tem- perature, the longer the lamp will be illuminated. All engines on Western Star vehicles comply with the requirements of the Federal (U.S.) Clean Air Act.

Once an engine is placed in service, the responsibil- ity for meeting both state and local regulations is with the owner/operator. NOTE: The engine electronics supply the cor- rect amount of fuel for starting the engine. Ac- celerator pedal pressure is unnecessary and could interfere with engine starting. IMPORTANT: Depending upon local jurisdic- tional emissions guidelines, vehicles that are domiciled outside of the U.S. and Canada may not have engines and/or emissions aftertreat- ment systems that are compliant with EPA07, EPA10, or GHG14 regulations. 5. Turn the ignition key to the START position. Re- lease the key the moment the engine starts. 6.

Apply load gradually during the warm-up period. 9.1