Engine Starting, Operation, and Shutdown Charge the batteries to full capacity. Replace damaged batteries. Engine Shutdown If equipped, turn off the load disconnect switch after the engine is shut down, to prevent bat- tery discharge. 1. With the vehicle stopped, set the parking brake and place the transmission in neutral. Have the alternator output checked at an au- thorized service provider. NOTICE Idle the engine one to two minutes before shut- ting it down. After hard operation, shutting down the engine without idling may cause damage to the turbocharger. Check the condition and tension of the drive belts.
Refer to the engine manufacturer’s operation manual for recommended heaters, low- viscosity lubricating oils, winter-grade fuels, and approved coolants. 2. Allow the engine to idle one to two minutes be- fore shutting it down. NOTICE NOTICE Except in an emergency, do not shut down the engine when the coolant temperature is above 194°F (90°C). To do so could damage the engine. For Detroit engines (EPA07 and newer), use of a winterfront is not recommended, as it can cause false fault codes with the engine and aftertreat- ment system, and possible emission component failures. 3. Turn off the ignition switch and shut down the engine.
If using a winterfront, leave at least 25% of the grille opening exposed in sectioned stripes that run per- pendicular to the charge-air-cooler tube-flow direc- tion. This assures even cooling across each tube, and reduces header-to-tube stress, and possible chance of component failure. For engine-specific guidelines, see below: Engine Cooling The cooling system used on all Western Star ve- hicles is a pressure type system. This raises the coolant boiling point, permitting higher operating tem- peratures. The coolant supplied in your vehicle will be a 50/50 mix of antifreeze and water, giving protec- tion down to (–37°C).
It is recommended that an antifreeze mixture be used at all times, as, in ad- dition to providing frost protection, it is a more effec- tive coolant, and has a higher boiling point than tap water. Cummins and Mercedes-Benz engines: A winterfront may be used to improve cab heating while idling, and only when the ambient temperature remains below 10°F (-12°C). Detroit engines (EPA07 and newer): Use of a winter- front is not recommended. Using a winterfront can cause excessive fan run time, increased fuel con- sumption, and failure of the DEF system heaters to operate correctly, resulting in fault codes, poor per- formance, and power reduction.
A winterfront should only be used temporarily in the following situations: Over-concentration of antifreeze or coolant condi- tioner can cause silicate to precipitate out of the coolant, forming silica gel on cooling system heat transfer surfaces (fuel coolers, oil coolers, radiators, and heater cores), resulting in reduced coolant flow and overheating. to improve cab heating while idling in an ex- tremely cold ambient temperature; Hard water (with high levels of calcium and magne- sium ions) encourages formation of silica gel. Do not use softened water as the salt used to artificially soften it is corrosive.
Most engine manufacturers pre- fer the use of distilled or de-ionized water to reduce the potential and severity of silicate dropouts. when the ambient temperature remains below -22°F (-30°C) and the engine is unable to maintain a running coolant temperature of 175°F (80°C) during normal over-the-road op- eration. Never exceed a 60/40 antifreeze-to-water ratio. If the level is low, add a 50/50 antifreeze solution to main- tain solution concentrations. Note that checking the 9.3