Emissions and Fuel Efficiency anything else that may be damaged or injured by prolonged exposure to high heat. Malfunction Indicator Lamp (MIL) To initiate a parked regen, perform the following steps. A steadily illuminated yellow malfunction indicator lamp (MIL) indicates an engine fault that affects the emissions. See Fig. 11.5 . 1. Park the vehicle away from all flammable materi- als, put the transmission in neutral, and set the parking brake. DPF Lamp When soot accumulates in the DPF and the DPF sta- tus lamp illuminates, see Fig. 11.6 , perform a parked regen or bring the vehicle up to highway speed to increase the load (thus starting an active regen). 2.
Start and warm the engine until the coolant tem- perature is at least 150°F (66°C). 3. Press and hold the regen switch for five sec- onds. The engine will increase rpm and initiate the regen process. As the regen process is initi- ated, engine rpm increases and the HEST lamp illuminates to indicate extremely high exhaust temperatures. If the DPF status lamp blinks while the CHECK en- gine lamp is illuminated, initiate a parked regen im- mediately in order to prevent an engine derate. If the red STOP engine lamp illuminates with the blinking DPF lamp and the CHECK engine lamp, begin a parked regen in order to prevent an engine shutdown. Park the vehicle and perform a parked regen. IMPORTANT:
The driver must remain with the vehicle during the entire regen cycle. 4. The regen cycle will finish after 20 to 60 minutes, at which time engine idle speed drops to normal and the vehicle can be driven normally. The HEST lamp is extinguished when vehicle speed exceeds 5 mph (8 km/h) or the system has cooled to normal operating temperature. High Exhaust System Temperature (HEST) Lamp Slow (10-second) flashing of the high exhaust sys- tem temperature (HEST) lamp indicates that a parked regen is in progress, and the engine’s high idle speed is being controlled by the engine software, not the vehicle driver. 5. To stop a parked regen at any time during the process:
depress the clutch pedal, brake pedal, or accelerator pedal; Steady illumination of the HEST lamp alerts the driver of high exhaust temperature during the regen process if the vehicle speed is below 5 mph (8 km/ h), or during a parked regen. See Fig. 11.7 . press and hold the regen inhibit switch until idle returns to normal; shut down the engine. Maintenance ATS Warning Lamps Authorized service facilities must perform any DPF service. For warranty purposes, maintain a record that includes: There are three warning lamps that alert the driver of high exhaust temperature, the need to perform a parked regen or service the DPF, or of an engine fault that affects emissions.
A decal attached to the driver’s sun visor explains the ATS warning lamps. See Fig. 11.3 . date of cleaning or replacement; vehicle mileage; particulate filter part number and serial number. See Fig. 11.4 for an explanation of the ATS warn- ings, and actions required to avoid engine protection sequences. Diesel Exhaust Fluid and Tank, EPA10 and Newer Engines Diesel Exhaust Fluid Diesel exhaust fluid (DEF) is used in the ATS to lower NOx in the exhaust stream. DEF is colorless 11.3