Doosan DX225LC-3 — 8. Light Switch

6. Engine Speed Control Dial The engine speed is controlled by the dial. Rotating it clockwise increases engine speed (rpm) and rotating it counterclockwise decreases engine speed. A Low Idle (Lowest engine speed). B High Idle (Highest engine speed). NOTE: The auto idle system will automatically reduce engine speed to "LOW IDLE" approximately four seconds after all the control levers are in the "NEUTRAL" position. This system is designed to reduce fuel consumption and noise. See “4. Auto Idle Selector/Buzzer Stop Button” on page 2-22. FG018094 Figure 9 7. Travel Speed Selector Switch O I II WARNING Do not operate the travel speed selector switch when machine is in motion.

Temporary loss of control could result. AVOID DEATH OR SERIOUS INJURY FG016016 This switch activates the automatic speed range for travel. Figure 10 O. In this position, "LOW" travel speed is selected. II. In this position, "AUTOMATIC" travel speed is selected. The travel speed automatically changes between "LOW" or "HIGH" range, depending on engine speed and travel motor loads. I. In this position, "HIGH" travel speed is selected. 8. Light Switch This switch is used to turn "ON" the lights. O I II O. In this position, all lights are "OFF". I. In this position, all illumination lights of the display monitor and the control switches are turned "ON". II.

In this position, all illumination lights and work lights are turned "ON". FG016017 Figure 11 IMPORTANT Do not leave display monitor or work lights "ON" when the engine is not running. Leaving lights "ON" with the engine stopped will discharge batteries. DX225LC-3 Operating Controls 2-10