Doosan DX225LC-3 — 31. One Touch Deceleration Button

30. Diesel Particulate Filter (DPF) Switch Used for manual (forced) regeneration or the inhibition (non-regeneration) of DPF system. O I II NOTE: Run machine at "LOW IDLE" and do not stop engine until regeneration cycle is completed. See “Diesel Particulate Filter (DPF) Regeneration Light and Switch” on page 3-24, for more information. IMPORTANT Figure 40 FG018280 Move safety lever to "LOCK" position for manual (forced) regeneration. If the equipment is moved or switched off while manual (forced) regeneration is in process, the regeneration will need to be restarted. O. The switch is automatically returned to this position, when it is released. I.

In this position, used for inhibited (non-regeneration) operation of DPF regeneration. The inhibited (non-regeneration) symbol on the display monitor will turn "ON". II. In this position, manual (forced) regeneration for DPF system is turned "ON". When the DPF regeneration warning symbol on the display monitor is turned "ON", use the DPF manual (forced) regeneration switch. NOTE: Turn "OFF" cutoff switch before forced regeneration. If the machine is moved or stopped while manual (forced) regeneration is in process, the regeneration will need to be restarted. 31.

One Touch Deceleration Button Press the button on the top of the left-hand work lever (joystick) to reduce engine speed to "LOW IDLE". When the button is pressed, the engine speed is immediately reduce to "LOW IDLE" rpm. When the button is pressed again, the engine speed will return to the setting of the engine speed control dial. FG027213 Figure 41 DX225LC-3 Operating Controls 2-20