Doosan DX225LC-3 — 33. Jog Switch Control Panel

3. Work Mode Selector Button Used to select the excavation, lifting, or attachment mode. Pressing the work mode selector button will display the available modes in the main window. Place the selection bar by turning the jog switch and select the mode by pressing the jog switch. FG018105 Figure 46 4. Auto Idle Selector/Buzzer Stop Button Auto Idle Function: When the auto idle system is activated, the engine will automatically reduce speed to "LOW IDLE" approximately four seconds after all the control levers are in the "NEUTRAL" position. This system is designed to reduce fuel consumption and noise.

When the auto idle selector button is pushed to "ON" position, an indicator symbol on display monitor turns "ON". When the auto idle selector button is pushed again, it is turned "OFF" and the engine speed will return to the setting of the engine speed dial and will remain at this speed despite control lever position, until engine speed dial is moved. FG018106 Figure 47 Buzzer Stop Function: When warning light appears and the buzzer sounds, use this button to "STOP" buzzer from sounding. 5. Camera Mode Selector/Escape (ESC) Button Camera window will appear when the button in the main window is operated.

The window will go back to the previous window when the button is operated in any other window than the main window (ESC). If a pop-up window appears, pressing the button will remove pop-up. FG018107 Figure 48 DX225LC-3 Operating Controls 2-22