2. Engine Oil Pressure Warning Symbol This symbol indicates when the engine starter switch is turned "ON", and should go "OFF" after the engine starts. For example, if the engine oil pressure becomes too low, the light will turn "ON" and a warning buzzer will sound. If this happens, stop engine immediately and determine the cause of the problem. If work is continued when this light is "ON", it will result in serious engine damage. HAOA620L Figure 66 IMPORTANT If work is continued when this light is "ON", it will result in serious engine damage. 3.
Engine Coolant Temperature Warning Symbol If engine coolant overheats, this symbol appears on the screen an alarm will sound, and the engine speed will be automatically reduced, until coolant temperature drops. Do not turn engine "OFF" because this will cause coolant temperature to rise and can cause engine to seize up because of heat surge. NOTE: Check the engine coolant temperature gauge. If the gauge pointer moves into the red zone, the engine coolant temperature warning light will turn "ON", a warning buzzer will sound, and the engine speed will be automatically reduced. Allow the engine to run at "LOW IDLE" until temperature gauge registers in the white zone again.
When the white zone is reached, allow the engine to idle for an additional three - five minutes before stopping the engine. If not allowed to idle, heat surge may develop which will damage the engine. Allowing the engine to idle will dissipate heat. Check the coolant level, look for a loose fan belt, inspect for debris around radiator, etc. HAOD350L Figure 67 When the temperature reaches the normal range, the engine speed will automatically recover. DX225LC-3 Operating Controls 2-30