7. If dirt or mud builds up in the track frame, raise each track and rotate and clean that track. IMPORTANT When using the boom and arm to lift any portion of the machine, roll the bucket until round base is against the ground. The angle of the arm to the boom must be at 90°. FG018394 Figure 40 Make sure that material buildup has been cleared. See Figure 40 and Figure 41. 8. The excavator can travel in water that comes up to center of upper carriage rollers. Make sure that footing is solid so the machine will not sink. See “Working in Water” on page 3-49. 90 - 110 NOTE:
If the machine is submerged to the point that water or mud gets into the swing bearing or center joint, stop machine operation. Remove machine from the submerged location to firm, dry ground. Do not operate until proper inspection and maintenance have been completed. Refer to the Shop Manual or contact your DOOSAN distributor. Figure 41 EX1300534 Straight Travel Pedal (Optional) WARNING AVOID DEATH OR SERIOUS INJURY 1. When moving travel controls forward, tracked excavator will move in the direction of the idlers. Wheeled excavator will move in the direction of steering axle. 2. Before moving, make sure there are no persons or property in the way or on the machine. No riders.
Sound the horn to alert workers and bystanders that you are about to move the machine. 3. Always be sure the path is clear during travel. 4. Use extreme caution when reversing travel. Be sure there is a clear path behind the machine. 5. Operate the travel control pedal smoothly to avoid sudden starts or stops. 6. Before leaving the operator's seat, make sure to lock out all control systems and stop engine to avoid accidental activation of controls. Operation 3-21 DX225LC-3