Working in Water IMPORTANT When working in water, do not exceed a slope of more than 15°. If the slope is over 15°, the rear part of the upper structure will be immersed in water, resulting in radiator fan and engine ECU damage. FG018426 Figure 101 When working in water, do not operate in water higher than the center of upper track roller(s) (1, Figure 102). If swing bearing gets wet, immediately grease it until all the old grease is purged from bearing. If water gets into swing gear housing, drain water immediately by removing lower inspection cover. Apply new grease. After working in water, purge old grease from bucket pins.
FG018427 1 Figure 102 Escaping From Mud Be very careful to avoid getting stuck in mud. Track On One Side Stuck NOTE: When using the boom or arm to raise the machine, always have the bottom of the bucket in contact with the ground. The angle between the boom and arm must be 90° - 110°. The same applies when using the bucket installed in the reverse direction. FG018428 Figure 103 When only one side is stuck in mud, use the bucket to raise the track and then lay boards or logs and drive the machine out.
Tracks On Both Sides Stuck When the tracks on both sides are stuck in mud and slipping, making it impossible for the machine to move, lay boards or logs as explained above and dig the bucket into the ground in front. Then pull in the arm as in normal digging operations and put the travel levers in the FORWARD position to pull the machine out. FG018429 Figure 104 Operation 3-49 DX225LC-3