DX225LC-3 Inspection, Maintenance and Adjustment 4-22 SERVICE ITEM PAGE Replace Hydraulic Oil Return Filter (After First 250 Hours) 4-45 Change Pilot Filter (After First 250 Hours) 4-45 Inspect Pins and Bushings of the Front End Attachments for Signs of Wear 4-45 Check Fluid Levels in Batteries 4-45 Inspect for Any Loose or Missing Nuts and Bolts 4-45 Inspect Fuel System Hose Clamps 4-45 500 Hour / 3 Month Service Perform All Daily, 50 and 250 Hour Service Checks 4-46 Grease Swing Gear and Pinion 4-46 Change Engine Oil and Filter 4-47 Clean Air-conditioning Outer Filter 4-48 Check and Clean Air-conditioning Inner Filter 4-49 Clean Radiator, Oil Cooler, Intercooler, Fuel Cooler and Air Conditioner Condenser Cores 4-50 Clean Outer Filter of Air Cleaner 4-51 Change of Water Separator & Pre Fuel Filter (Fuel Prefilter) 4-53 Change Main Fuel Filter 4-54 Clean Air Compressor Filter (Optional) 4-55 Check Oil Level in Travel Reduction Device (One on Each Side of Unit) 4-56 Change Oil in Travel Reduction Device (One on Each Side of Unit) (After First 500 Hours) 4-56 Change Swing Reduction Device Oil (Drain and Refill After First 500 Hours) 4-56 1,000 Hour / 6 Month Service Perform All Daily, 50, 250 and 500 Hour Service Checks 4-57 Grease Swing Reduction Device 4-57 Change Hydraulic Oil Tank Breather Filter 4-57 Replace Hydraulic Oil Return Filter 4-58 Change Pilot Filter 4-59 Change Oil in Travel Reduction Device (One on Each Side of Unit) 4-60 Change Swing Reduction Device Oil 4-61 Change Air-conditioning Outer Filter 4-62 Change Air-conditioning Inner Filter 4-62 Check Air Conditioner Refrigerant 4-63 Change Fuel Cap Filter 4-64 Check and Adjust Engine** 4-65 2,000 Hour / Yearly Service Perform All Daily, 50, 250, 500 and 1,000 Hour Service Checks 4-66 Replace Outer and Inner Air Cleaner Filters 4-66 Change Radiator Coolant 4-68 ChangeAir Compressor Filter (Optional) 4-69 Hydraulic Oil Exchange and Suction Strainer Cleaning 4-70 Check Alternator and Starter** 4-72 Check All Rubber Antivibration Shock Mounts 4-72 Perform and Record Results of Cycle Time Tests 4-72 Inspect Machine to Check for Cracked or Broken Welds or other Structural Damage 4-72 Check, Adjust Valve Clearance** 4-72