Doosan DX225LC-3 — Hydraulic Oil Exchange and Suction Strainer Cleaning

5. Drain hydraulic oil from tank into a container capable of holding 200 liters (52.8 U.S. gal.). After draining tank, install drain plug. WARNING AVOID DEATH OR SERIOUS INJURY Be careful of squirting oil when removing drain plug. FG020067 Figure 115 NOTE: Used filter and used oil should always be disposed of according to local laws and regulations. 6. Carefully remove bolts and cover (2, Figure 117) from top of hydraulic oil tank. There is a spring (3, Figure 117) under the cover that will force the cover up. 7. Remove spring (3, Figure 117) and strainer (5, Figure 117), by pulling on rod (4, Figure 117). A 8. Clean inside and outside of strainer. Replace strainer if it is broken. 9.

Position strainer (5, Figure 117) on boss portion of suction pipe (6, Figure 117). NOTE: Measurement "A" is 614 mm (24.17 in). FG021459 Figure 116 10. Fill the hydraulic oil tank. Check level using sight gauge on side of tank. 1 2 11. Place spring (3, Figure 117) on rod (4, Figure 117) and assemble cover (2, Figure 117). 12. After replacing and cleaning the hydraulic oil, filter, and strainer, vent the system. See “Venting and Priming Hydraulic System” on page 4-102. 3 IMPORTANT 4 When the hydraulic breaker is being used, because of the higher heat generated by this unit, use replacement intervals recommended under the “Hydraulic Oil and Filter Service Intervals” on page 3-59. 5 13.

Check level of hydraulic oil tank. (See page 4-25) 6 ARO1720L Figure 117 Inspection, Maintenance and Adjustment 4-71 DX225LC-3