Doosan DX225LC-3 — General

ENGINE COOLING SYSTEM General Keeping an engine's cooling system in peak operating condition can have many benefits in keeping a machine in good operating condition. A properly functioning cooling system will improve fuel efficiency, reduce engine wear, and extend component life. Always use distilled water in the radiator. Contaminants in tap water neutralize the corrosion inhibitor components. If tap water must be used, Refer to “Table of Standards for Allowed Tap Water” on page 4-94. Water that has been treated with a water softener also contains salt that will cause corrosion of components.

Water from creeks and stagnant pools usually contain dirt, minerals and/or organic material that are deposited in the cooling system and impair cooling efficiency. As such, the use of distilled water is recommended. Engine coolant shall be mixed with antifreeze solution and water in ratio of 50 : 50. Coolant shall be checked every 500 hours of operation for ensuring adequate concentration of antifreeze solution and additives. Engine overheating is often caused by bent or clogged radiator fins. The spaces between the fins can be cleaned by use of air or water under pressure.

When straightening bent fins, use care not to damage the tubes or break the bonding joint between the fins and the tubes. WARNING AVOID DEATH OR SERIOUS INJURY Pressure at air nozzle must not exceed 2 kg/cm 2 (28 psi). Always wear goggles when using compressed air. Do not pour cold water into radiator when engine is hot and water level is below the top of the tubes. Such action could result in damage to engine cylinder heads. Heavy-duty diesel engines require a balanced mixture of water and antifreeze. Drain and replace the mixture 1 year or 2,000 hours of operation, whichever comes first. This will eliminate buildup of harmful chemicals. Antifreeze is essential in any climate.

It broadens the operating temperature range by lowering the coolant's freezing point and by raising its boiling point. Do not use more than 50% antifreeze in the mixture unless additional antifreeze protection is required. Never use more than 60% antifreeze under any condition. DX225LC-3 Inspection, Maintenance and Adjustment 4-92