Visibility Information A rear view camera (if equipped) and mirrors provide the operator with additional means to see the work area. NOTE: These devices may vary from one region to another, depending upon local and regional regulations. If a machine is moved or sold into another region or marketplace, it is the owner's responsibility to make sure it complies with all applicable regulations. WARNING Failure to check for and clear people from the surrounding area of a machine can result in death or serious injury. The operator should make sure that visual aids (mirrors and camera(s)) are in proper working condition.
AVOID DEATH OR SERIOUS INJURY Your machine may be equipped with visual aids such as mirrors or a rear view camera. Even with these aids, there still may be areas around the machine which cannot be seen from the operator's seat. Always keep personnel and bystanders out of the work area. Be careful when operating and always look in direction of travel. Adjust visual aids for best visibility around machine. When swinging work equipment or backing up, press camera button (if equipped) to change display mode on display monitor so you can check rear and side of machine. Before moving machine, look around work site and use mirrors and display monitor to confirm that no one is in the work area.
While operating or traveling in places with poor visibility it may be impossible to confirm condition of work site. Inspect and remove any obstacles around the machine that could be damaged and keep other personnel out of the work area. Inspect equipment and repair immediately if there are problems with visual aids. If machine cannot be fixed immediately, DO NOT use the machine. Contact your DOOSAN distributor and arrange for repairs. Work Site Rules If visibility cannot be sufficiently assured, use a flagman. The operator should pay careful attention to signals and follow instructions from flagman. Signals should only be given by one flagman.
When working in dark places, turn "ON" work lights and front lights on the machine. Set up additional lighting in area. Stop operations if there is poor visibility, such as fog, snow, rain, or sandstorms. DX225LC-3 Safety 1-36