XT855 Operator’s Manual Controls - 29 Joysticks p CMW Item Description Notes 1. Engine stop button Stops engine immediately. IMPORTANT: • Except in an emergency, move throttle to idle before using stop switch. 2. Right joystick c00ic223h.eps With work mode switch in tool carrier mode: • To move lift arms down, push. • To float, push forward to end. Control will lock into float position. • To move lift arms up, pull. • To curl attachment up, move to left. • To curl attachment down, move to right. IMPORTANT: • Control can perform more than one action at a time. Using them together, operator can “feather” or combine operations. • Do not exceed rated operating capacity when lifting loads.
See page 98. With work mode switch in excavator mode: • To open bucket, move right. • To close bucket, move left. • To move dipper in, pull. • To move dipper out, push. IMPORTANT: SAE excavator control pattern is shown. For information about ISO control pattern, see “Operate Controls” on page 69. 3. Attachment drive switch F R c00ic228h.eps To engage attachment drive in forward, push top. Switch will lock into forward position. To engage attachment drive in reverse, push and hold bottom. IMPORTANT: See “Auxiliary hydraulic fluid flow/pressure indicator” on page 24.