Service - 80 XT855 Operator’s Manual Recommended Lubricants/Service Key p Engine Oil Temperature Chart Temperature range anticipated before next oil change Approved Coolant Any ethylene glycol based coolant is approved for use with this unit. However, it was filled with John Deere Cool-Gard coolant before shipment from factory. Add only Cool-Gard or any fully-formulated, ethylene glycol based, low-silicate, heavy-duty diesel engine coolant meeting ASTM specification D6210 (fully formulated) or D4985 (low silicate). Before using any other kind of coolant, completely flush radiator. NOTICE: Do not mix heavy-duty diesel engine coolant and automotive-type coolant.
This will lead to coolant breakdown and engine damage. Approved Fuel The engine is this unit is designed to run on diesel fuel. Use only high-quality fuel meeting ASTM D975 No. 2D, EN590, or equivalent. At temperatures below 32°F (0°C), winter fuel blends are acceptable. See engine operation manual for more information. Biodiesel blends up to 5% (B5) are approved for use in this unit. The fuel used must meet the specifications for diesel fuel shown above. Extra attention is needed when using biodiesel, especially when operating in cold weather or storing fuel. Contact your Ditch Witch dealer or the engine manufacturer for more information.
Fuel sulfur content should be less than 5000 ppm (0.5%). Worldwide, fuel sulfur regulations vary widely. Fuel used should always comply with local regulations. Do not use lube oil meeting API CJ-4 (or other low SAPS equivalent) if fuel sulfur content is above 5000 ppm (0.05%, low sulfur diesel in the U.S.). CMW