Installation Procedure The installation.procedure is the reverse of the removal procedure. Note: When the oil in the clutch housing is contaminated or the inside of the housing is dirty, drain oil from the drain plug and clean the inside of the housing. Use sandpaper and remove dirt (adhesion of rust, anticorrosive or impurities) on the friction surface of the pressure plate. Apply a thin coat of chassis grease on the input shaft spline portion, release bearing surface in con - tact with the release lever, and release hub surface in contact with the release fork. When installing the clutch cover, carefully operate to prevent deformation or damage of the oil clutch injection nozzle.
pcs.) after installing the clutch cover. Check the hydraulic oil level. Always remove the service bolts (3 When oil in the clutch housing is drained, add the same amount of new hydraulic oil in the housing. Point Operation [Point 1 I Match marks Installation: Install the oil clutch nipple with its injection hole in the correct direction. I Section A - A