T = N.m (kg - cm) Ift-lbl 1 Torque converter oil 2 Engine Wltorque converter 3 Torque converter housing ASSY Removal Procedure 1 Drain torque converter oil. 2 Remove the engine Wltorque converter. (See page 1 - 1 2 in the engine section.) 3 Disconnect the engine and torque converter housing ASSY. (See steps 1 t o 4 of the removal proce - dure on page 1 - 1 6 in the engine section.) 4 Remove the torque converter ASSY. [Point 11 5 Remove the oil pump Wlstator shaft. [Point 21 6 Remove the stator shaft. 7 Remove the oil pump gear. [Point 31 8 Remove the oil seal. [Point 41 Installation Procedure The installation procedure is the reverse of the removal procedure.
Note [7.24 - 11.58 ft - lb] See the note for the engine installation procedure. (See page 1 - 13 and 1-16.) Stator shaft set bolt tightening torque: T = 9.81 - 15.69 N-m (100 - 160 kg - cm)