Toyota — Torque Converter

Reassembly: Adjust the clearance between the backing plate and clutch disc. 1. Install the camber plate, clutch plate, clutch disc, back - ing plate and snap ring on the clutch drum. 2. Set a dial gage on the upper face of the clutch disc and lift the clutch disc with a screwdriver t o measure the clearance with the backing plate. Standard clearance: 4-disc specification: 0.65 - 1.2 mm (0.0256 - 0.047 in) 5 - disc specification: 1.0 - 1.6 mm (0.039 - 0.063 in) 3. If the measured value does not satisfy the standard, select and use an appropriate backing plate. Backing plate thickness 4 - disc specification:

A = 7.8 and 8.3 mm (0.307 and 0.327 in) 5 - disc specification A = 3.0 and 3.5 mm (0.1 18 and 0.138 in) [Point 41 Disassembly~reassembly: SST 09220 - 22000 - 7 1 Inspection: Measure the free length of the clutch return spring. Free length: 92.1 mm (3.626 in) Limit free length: 85.0 mm (3.346 in) [Point 51 Inspection: Measure the clearance between the clutch piston and piston ring. Standard clearance: 0.1 5 mm (0.0059 in) Inspection: Clean the check valve installed in the clutch piston by blowing compressed air. Reassembly: Install the piston ring with the side with the " R " punch mark facing the hydraulic oil pres - sure side.