INCHING PEDAL ADJUSTMENT Stop lamp switch Brake pedal link Torque converter ht 8 mm (0.31 in) (stroke) I Adjusting 1. Adjust the inching pedal height and play. (1 Adjust the stop lamp switch or stopper bolt length (dimension C ) to make the inching pedal height (dimension A or 6) satisfy the standard below. (2) Adjust the inching cable adjusting nut to make the torque converter inching lever 8 mm (0.31 in) at the position (dimension F) where the inching pedal link plate come into contact with the brake pedal link to start brake application. The brake application start position means the position where the brake master cylinder rod is stroked by 8 mm (0.31 in). Unit: mm (in) A:
Dimension without pad B: Dimension with pad C, E and F: Reference dimensions E: Pedal play correspond - ing to wire play (G) [Reference] The inching pedal play is determined as the result of the above adjustment, but it is recommended to use wire cable play (dimension G ) in the inching lever clevis as the reference. G = 0.5 mm (0.020 in) A B C (Reference) E (Reference) F (Reference) - 140 145 (5.51 -5.71)( - 145 150 - 5.71 5.91) 12 (0.47) 17.5 (0.689) - 3 5 (0.12 -0.20) - 56 60 - (2.20 2.36)