Toyota — Transmission

SHIFT ROD ADJUSTMENT I . Adjust the shift rod length (1 ) With the shift lever set in the neutral position, adjust the length of each shift rod (forwardlreverse and I st & 2nd) to make the clearance (dimension A) between the lever knob and engine hood satisfy the following value: A = 10 - 15 mm (0.39 - 0.59 in) (2) Further adjust the shift rod length within the range of dimension A to make the deviation (diameter B) be - tween shift levers LH and RH satisfy the following value: B = 5 mm (0.20 in) or less (3) Shift rod length (diameter L: reference) Unit: m m (in) Approx. 17 mm (0.67 in) Gasoline Gasoline engine models i model I Diesel engine PTFi Diesel engine model models Approx.

17 mm (0.67 in) The dimensions shown above for diesel engine models are in the retracted state as the rod has a certain degree of looseness. 2. Adjust the brace rod length. (1 ) Install the brace rod with adjustment to the length be - tween the transmission and shift lever shaft (dimen - sion C). After installation, check if the transmission side is forcibly pulled or forced in by turning the rod. Check looseness at the fitting between the end bush - ing on the transmission side and the pin in the 1DZ and 22 model in 2 and 3 ton series. (2) Brace rod length (dimension C:

reference) 1.2 ton series C = 202 mm (7.95 in) 3 ton series C = 218.5 mm (8.602 in) 1st & 2nd rod Forward1 reverse rod 266 (10 .47) 3 2 9 (12 .95) 3 ton series 282 ( 1 1 .10) 3 4 5 (13 .58) 1.2 ton series 266 (10 .47) 3 2 9 (12 .95) 3tonseries 2 8 2 ( 1 1 . 1 0 ) 3 4 5 ( 1 3 . 5 8 )