Toyota — Steering

POWER CYLINDER 4 Y 2 Power cylinder rod end position 4 1 Undercover and tire cover L H 5' 8 Power cylinder end Removal Procedure 1 Remove the undercover and tire cover LH (in 22 engine models only). 2 Rotate the steering wheel and stop at the position where the power cylinder rod end comes out from the rear axle beam. 3 Disconnect the piping. 4 Disconnect the drag link end. [Point 11 5 Disconnect the power cylinder rod end. [Point 21 6 Disconnect the power cylinder bottom end. [Point 31 7 Remove the power cylinder ASSY Wlpower cylinder end. 8 Disconnect the power cylinder end. [Point 41 Installation Procedure The installation procedure is the reverse of the removal procedure. Note:

See the steering link adjustment (on page 9 - 26) for the power cylinder installed dimension. Power cylinder end castle nut tightening torque. 1.2 ton series: T = 68.65 - 98.07 [50.65 - 72.35 ft - lb] 3 ton series: T = 147.10 - 196.13 N-m (700 - 1000 kg - cm) N-m (1 500 - 2000 kg - cm) 1108.53 - 144.70 ft - lb]