Drag Link End Installed Dimension 1 Adjust the .installed dimension to the value shown below by adjusting the screwed - in dimensions of the drag link ends. Note: The screwed - in dimensions of the drag link ends at both ends shall be the same. If the end angle is incorrect when installing the drag link on the vehicle, adjust the angle by loosening the end lock nut. Drag link end lock nut tightening torque T = 117.68 - 147.10 i86.82 - 108.53 ft - lbl After installation, operate the drag link to confirm no undesirable contact with the frame or other part.
N-m (1200 - 1500 kg - cm) / 1 ton series i 2.3 ton series - (Actual l e n g t h ' Installed angle A Installed angle B (reference value) (reference value) mm (in) rnm (in) C (actual length) D (actual length) mrn (in) 1056 * 0.20) & 5 2.5' 110 ° + ton series (41.57 40° & * 2.5' 7 0 (2.76) 7 0 (2.76) 2 ton series (51.7710.20) 1 3 1 5 * 5 95' 2.5' 9O 12.5O t t series (55.91 1 0 . 2 0 ) 1420*5 t T T t