Toyota — Brake

KEY POINTS IN SERVICE JOBS 1. Parking brake knob (A) removal and installation procedure: (1 ) Remove the 'lever. (2) Immerse the knob in hot water (70 - 80 10 to 20 seconds. (Do not use water at 100 OC (1 58 - 176 OF)) for (6) from the front face of the knob. (4) Extract the knob upward. (5) Operate in the reverse order for installation. OF) or above.) (3) Remove plug OC (212 2. Key points for reassembly (C). (2) Coat grease on the rod threaded portion (D). (3) Sufficiently apply MP grease at the compression spring installing portion (1) Coat grease on the link pin and moving surface (E). (4) Coat thread tightener (08833 - 00070) on the threaded portion (F).

(5) After fully tightening knob (H). Tightening torque T = 9.81 - 15.69 (G), return it by a half turn, and tighten knob N.m (100 - 160 kg - cm) [7.24 - 11.58 ft-lbl 3. Lock parking cable set dimension (L) on each of the left and right sides to the following value: L = 0 - 2 rnrn (0 - 0.08 in) 4. Adjust the parking brake lever operating force. (See page 10 - 27.)