lnching Pedal Adjustment (in Models with Torque Converter Only) - Stop lamp switch or stopper bolt Stop lamp switch \ / lnching pedal link plate lnching pedal lrnk plate Brake pedal lrnk ' ~ o e board Torque converter inchrng lever Torque converter ht 8 Adjusting mrn (0.31 in) (stroke) 1. Adjust the inching pedal height and play. (1 ) Adjust the stop lamp switch or stopper bolt length (dimension C) to make the inching pedal height (dimension A or (2) Adjust the inching cable adjusting nut to make the torque converter inching lever 8 mm (0.31 in) at the position (dimension B) satisfy the standard below.
F) where the inching pedal link plate come into contact with the brake pedal link to start brake application. The brake application start position means the position where the brake master cylinder rod is stroked by 8 mm (0.31 in). : A: Dimension without pad Unit: mm (in) ,............................................................., C, E and F: Reference i i B: Dimension with pad i : dimensions ; i : Pedal play correspond - ing to wire play (G) [Reference] The inching pedal play is determined as the result of the above adjustment, but it is recommended to use the inching lever clevis and wire cable play (dimension G) as the reference.
G = 0.5 mrn (0.020 in) A B C (Reference) E i F (Reference) (Reference) - 140 145 - (5.51 5.71) - 145 150 - (5.71 5.91) 12 (0.47) 17.5 10.6891 - 3 5 (0.12 -0.20) - 56 60 - (2.20 2.36)