12 - 10 OIL LEAK TEST LIFT CYLINDER 1. Set the mast in the vertical position with the standard load on the fork. Lift the fork by 1 to 1.5 m (40 to 59 in). 2. Slowly tilt the mast fully forward, and stop the engine. After 5 minutes, disconnect the oil control valve to oil tank hose. Place a measuring cylinder under the elbow and measure the amount of oil leaking in one minute. Standard oil leak amount (at lift port): 16 cc (0.98 cu - in) or less Note: If the natural drop is great even though the oil leak amount is within the standard, the lift cylinder packing is defective. TILT CYLINDER 1. Set the mast in the vertical position with standard load on the fork.
Lift the fork by about 50 cm (1 9.7 in) and stop the engine. 2. After waiting for 5 minutes, disconnect the oil control valve to oil tank hose. Place a measuring cylinder under the elbow and measure the amount of oil leaking in one minute. Standard oil leak amount (total for lift and tilt): 32 cc (1.95 cu - in) or less ' 3. The leak amount at the tilt port is the total leak amount i less the leak amount from the lift port. Note: If the natural forward tilt is great even though the oil leak amount is within the standard, either the tilt lock valve or the tilt cylinder packing is defective.