Toyota — Cylinder

Note: V.SV.FV mast. The flow regulator valve is installed on the outer mast side in case of the FSV mast. The description here is for the flow regulator valve for the I 1 Inner mast I Removal Procedure 1 Hoist the inner mast. [Point I ] 2 Remove the flow regulator valve. Installation Procedure The installation procedure is the reverse of the removal procedure. Note: Flow regulator valve tightening torque T = 58.84 - 68.65 N-m (600 - 700 kg - cm) 143.41 - 50.65 ft-lbl I Point Operation /' I I [Point 1 Removal~installation: Sling the inner mast (middle mast) with a wire rope and hoist it.

Set the SST on the inner mast (middle mast) tie beam and lower the inner mast until it comes into contact with the SST. SST 0961 0 - 22000 - 7 1