TEST METHOD Note: A bench test shall be performed for strict testing. Since it is impossible in actual service jobs, install the oil pump on an actual vehicle and judge the oil pump delivery quality by the cylinder operation state. 1. Install an oil pressure gage and engine tachometer. (1) Set the oil pressure gage on the oil control valve. (2) Set the engine tachometer on the engine. 2. Operate the oil pump for running in. (1) Start the engine. With the oil control valve lever in the neutral position, run the engine for 1 0 minutes at 500 to 1000 rpm. 3. If no abnormality is found in the oil pump, run the engine for 10 minutes by raising the speed t o 1500 to 2000 rpm. Note:
If any abnormality is found in step 2 or 3 above, immediately stop the engine and disassemble the oil pump again. 4. Check if the relief set pressure of the oil control valve is as specified. See the oil control valve ad- justment section (on page 16-9) for details. 5. Check if the engine speed is as specified. See the engine speed adjustment section (on page 1 - 1 7) for details.