Toyota — Oil Control Valve

ADJUSTMENT Note: Always make adjustment according to the procedure described below. Careless adjustment may generate a high pressure to cause damage to the oil pump or other hydraulic devices. Always check that the no - load maximum speed is as specified. 1. Install an oil pressure gage. (1 Remove the oil pressure detection plug 6- 18UNF - 2B) installed on top of the oil control valve, and install the oil pressure gage. (911 2. Check loosening of the adjust screw. (1 1 Remove the cap nuts and packings on top of the re - lief valves LH and RH. Loosen the lock nut and loosen the adjust screw to a degree not t o come off from the body. 3.

Start the engine and check for no oil leak or abnormal noise. 4. Adjust the lift side relief pressure. (1) Set the control lever to the lift position and gradually tighten the adjust screw on the left side until the fork starts to rise. (2) Run the engine at the maximum 'speed, and read the pressure gage when the fork is raised t o the maxi - mum height. Adjust the oil pressure then to the specified level by turning the adjust screw and lock with the lock nut. 5. Adjust the tilt side relief pressure. (1) Set the control lever at the backward tilt position, and gradually tighten the adjust screw on the right side until the mast starts to be tilted backward.

(2) Run the engine at the maximum speed, and read the oil pressure gage when the mast is tilted fully back - ward. Adjust the oil pressure then t o the specified level by turning the adjust screw and lock by the lock nut. Relief set pressure Unit: kPa (kg/cm2) [psi] 6. After the adjustment, insert the packing and tighten the cap nut. Inspect the relief pressure again. 7. Remove the oil pressure gage, and tighten the plug. 1 ton series 2.3 ton series Lift 17160+:~O (17 5+3 [2490+G01 1 8 1 4 0 + (1 85':) [2630+;Ol Tilt 1 1770+:~O (1 20+3 [ 1 7 1 0 + ~ 1471 O+;'O ( 1 50':) ~ 1 [ 2130+;Ol