Removal Procedure 1 Remove the cover plate. 2 Remove the drive plate set bolts (6 pcs.). [Point 11 3 Slightly hoist the torque converter housing. 4 Remove the torque converter housing and engine connecting bolts to disconnect the torque con - verter housing, and remove the engine. 5 Remove the flywheel. 6 Remove the starting motor. 7 Remove the torque converter end plate. Installation Procedure The installation procedure is the reverse of the removal procedure. Note: Tighten the flywheel set bolts after applying thread tightener (08833 - 00070). The tightening torque for each part is as follows: Unit: N.m (kg - cm) [ft-lbl 7 7 1 Point Operations [Point 1 I Removal.lnstallation:
Rotate the flywheel by using a crankshaft pulley set bolt. Torque converter end plate set bolt - - - 49.03 78.45 (500 800) [36.18 57.881 Drive plate set bolts (for connecting to the engine crankshaft) - - 5K.4Y: 56.88 64.72 (580 660) [41.96- 47.751 - - - 1 DZ.22: 76.49 93.16 (780 950) L56.43 68.731 Drive plate set bolts (flywheel set bolts) (for connecting to torque converter) - - 14.71 21.57 (150 220) [10.85- 15.921 Torque converter housing set bolts - - - 29.42 44.13 (300 450) [21.71 32.561