No - load Maximum Speed Inspection and Adjustment 1. Warm up the engine. (1 ) To decrease the speed (2) To increase the speed 58OF) or above Hydraulic oil temperature: 76OF) or above Engine oil temperature: Coolant temperature: 80°C (1 70°C ( 1 50°C (1 22OF) or above Adjusting screw 2. Install the engine tachometer. Maximum speed adjustment 3. lnspect the no - load maximum speed. No - load maximum speed 5K: 3050 * 50 rprn 4Y (1 * 50 rprn 4Y (3 * 50 rprn - 2 ton series): 2600 ton series): 2800 4. Adjust the no-load maximum speed. (1 ) Remove the sealing wire. (2) Fully depress the accelerator pedal, and make ad - justment by means of the air governor adjusting nut and screw. I 5.
lnspect the relief speed. (1 Relief speed adjustment ) Operate the material handling lever when the engine is running at the maximum speed and measure the engine speed in the full relief state. Confirm that the speed decrease (relief down) satisfies the following value: Engine speed down at full relief 5K: 250 rprn or less 4Y (1.2 ton series): 250 rprn or less 4Y (3 ton series): 250 rprn or less 6. Seal the engine with wire after adjustment. Note: Turn the adjusting nut clockwise to increase the engine speed. Turn the screw clockwise to increase the engine speed. If the engine speed decrease in relief state is excessive, turn the adjusting nut clockwise and the screw counterclockwise.
In the process of this adjustment, the engine is about to start hunting. Stop adjustment immediately before hunting starts. If the engine running at the maximum speed is not stabilized (hunting), turn the adjusting nut coun - terclockwise and the screw clockwise. Excessive turning may increase the relief down to cause hunting. If the relief down is about 200 rprn in the new vehicle state or is 300 rprn or above, make adjust - ment by means of the engine, carburetor and air governor.