Toyota — Engine

INSPECTION 1. lnspect the battery fluid level. (1) lnspect if the battery fluid level is in the range of UP- PER ++ LOWER, If insufficient, add distilled water to the UPPER level. 2. lnspect the specific gravity of the battery fluid. (1) Use a hydrometer and measure the specific gravity of the battery fluid. (68OF)) Calculating equation S20 Standard: 1.280 (at 20°C = St + 0.0007 (t - 20) S20: Specific gravity converted t o (68OF) St: Measured specific gravity at t ° C t: Fluid temperature at the time of measurement 20°C 3, lnspect the battery terminals. (1) If battery terminals are contaminated to white, clean then and apply a thin coat of MP grease on termi - nals. 4.

Install the battery terminals and the harness connect - ing portion for loosening. (1 Retighten the battery terminals and the harness con - necting portion. Battery Removal 1. Disconnect battery terminals. Note: Disconnect the negative terminal first. 2. Remove the battery stopper. 3. Remove the battery. Battery Installation Reverse the removal procedure.