Point Operations [Point 1 I Disassembly: Punch a match mark on the clutch cover and pressure plate. Reassembly: Assembly by aligning the match mark. [Point 21 Reassembly: Carry out reassembly and adjustment accord - ing to the following procedure. 1. Adjust the release bearing plate height. (1 Adjust the pressure plate height from the clutch cover mounting plane to the following value by using serv - ice bolts ( 3 pcs.). Pressure plate height: 8.8 mm (0.346 in) (2) Apply a thin coat of chassis grease on the spherical face of the adjusting nut before installation.
(3) Make adjustment by the adjusting nut to make the release bearing plate height from the clutch cover mounting plane satisfies the following standard. + 0.020 in) Release bearing plate parallelism (inclination): 0 . 4 mm (0.016 in) or less Release bearing plate height: 59 k 0 . 5 mm (2.32 2. Use a press to press the release bearing plate several times with a stroke of 8 - 1 0 mm (0.31 - 0.39 in) and confirm no abnormal motion. Never let the stroke exceed 12 m m (0.47 in). 3. Check the dimension in step 1 again. 4. Assemble the nut lock plate and lock spring. [Point 31 Disassembly:
After removing the service bolts pcs.) while holding the clutch cover with a press, gradually release the pressing force to remove the clutch cover. ( 3 Reassembly: Install service bolts pcs.) while holding the clutch cover down with a press. (3