REMOVAL - INSTALLATION \ 1 \ 3 5 1 Brake flu~d 2 Toe board Removal Procedure 1 Disconnect the clutch side hose from the reservoir tank and drain the brake fluid. 2 Remove the toe board. 3 Disconnect the hose. 4 Remove the push rod clevis pin. 5 Remove the clutch release cylinder. Installation Procedure The installation procedure is the reverse of the removal procedure. Note: [10.85 - 15.92 ft-lbl See the clutch adjustment section (page 2 - 23) for the adjustment after installation. Carry out air bleeding. (See page 2-22.) Clutch release cylinder set bolt tightening torque T = 14.71 - 21.57 N-m (150 - 220 kg-cm)