Toyota — Clutch

REMOVAL - INSTALLATION 4 5 1 Brake fluid 2 Toe board and rubber cover Removal Procedure 1 Disconnect the clutch side hose from the reservoir tank and drain the brake fluid. 2 Remove the toe board and rubber cover. 3 Disconnect the piping. 4 Remove the push rod clevis pin. 5 Remove the clutch master cylinder Installation Procedure The installation procedure is the reverse of the removal procedure. Note: See the clutch adjustment section (page 2 - 23) for the adjustment after installation. Carry out gir bleeding. (See page 2 - 22)